Low Electrical Noise

The PID-10 temperature control system is designed for very low noise heating of electrophysiological experiments as noise sensitive as single ion channels. The PID-10 system is housed in a small cabinet that can be located near the experimental site. It has a built-in line operated power supply (optional external 12 volt Battery supply mode). The PID-10 guarantees low noise operation and has special overheating protection features to prevent the preparation and stage from damage.

The PID-10 incorporates two (Bath and Stage) very small temperature sensors Multiple temperature probes allow you to stabilize temperature in large volumes (Petri dishes). There is also an optional third external sensor for other monitoring applications. There is a SET control with direct readout (XX.X °C). A PID (proportional-integral-derivative) controller with adjustable parameters allows for the ultimate tuning of the PID-10 to the experiment. A high-power protected output stage provides 30 watts of power.

PID-10

FEATURES:

· Sophisticated Proportional-Integral-Derivative control circuit.

· Low noise: designed for single channel patch electrophysiology experiments.

· 30 watts of power maintains temperature during fast perfusion.

· Accurate temperature control: room to 60°C with stability of ± 0.1°C or better.

· Exact fit to microscopes: specify microscope model when ordering adapter plate (ADPT).

· Pre-heats perfusion solutions: perfusion lines run through the heating stage before entering bath chamber.

· Heating stages: for use with culture dishes or with Perfusion Recording/Imaging Chambers supplied by Dagan. Can be used with glass bottom dishes.

· Overheating protection: no risk to burn the heating stage.

· Output to monitor temperature. Input to set temperature.

· Inhibit Mode: no power switching during sensitive recordings.

· Optional External power supply: can operate from 12 volt batteries.

HW-101 Heating Stage

For use with 35mm Culture Dish

HW-104 Heating Stage

For use with Dagan RCP- and ICP- series Recording Chambers

Price:

PID-10

PID-B

HW-101

HW-104

ADPT

TH-30

PID-10 - 30 Watt Single Channel Heater Controller

Optional Battery input jacks (allows PID-10 to be run from 12V battery)

Heating Stage for use with 35mm Culture Dish

Heating Stage for use with Dagan Recording chambers

Adapter Plate to mount heater stages to microscope

(Indicate microscope model)

Spare Thermistor for HW-30/PID-10

$1,395

$145

$495

$55

$85

Warning: This equipment is not intended for use in human applications or human experimentation.

[ Home | News | Products | Ordering | Feedback ]

Dagan Corporation Minneapolis MN USA 612-827-5959 (FAX 612-827-6535) Email: info@dagan.com 9/22/06